In order to prevent interference
In order to prevent interference, the encoder cable is kept apart from the frequency converter, other equipment, and high-power equipment’s connecting cables. The conventional method can match the actual position/angle value after the collected grey code is converted into ordinary binary code. *Elastic coupling is preferable because it significantly reduces the eccentric problem brought on by poor installation accuracy or abrasion. *The encoder cable should be made of high-quality shielded twisted copper cable, which can cut down on signal attenuation and interference from outside the system. The standard of changing over paired dim code into normal twofold code is to keep the most noteworthy piece of dark code as the most noteworthy piece of regular double code. The high bit natural binary code is distinct from the second high bit grey code, which is the second highest bit natural binary code. Similar to the second high bit natural binary code, the other bits of natural binary code are similar. Installation Instructions for Rotary Encoders *Prevent loosening during use due to vibration. *Please ensure that the load cannot exceed its maximum allowable value and deviation when connecting the encoder. *To prevent the screw from becoming loose when the encoder coupling shaft is in use, secure it. 4.1 The Setting Check to see if there are any nearby sources of interference. The encoder is a precise instrument that can be easily tampered with. It will also have negative effects on normal use if it is affected. Temperature and dampness likewise should be concerned and figure out the extent of gear prerequisites. 4.2 Axle Weight When installing the rotary encoder, you should also be aware of its allowable range and pay close attention to its shaft load. The output circuit will be harmed if the signal line is connected to either DC power or AC power. 4.3 Association In association, the administrator ought to keep away from an unbending association with the encoder yet take the plate spring. During the installation process, the encoder should also be gently pushed into the quilted shaft. If the encoder is knocked, it will be damaged and the shafting will be affected.